P2407: The signal of the fuel vapour leak detection pump fails now and then
The signal of the fuel vapour leak detection pump fails now and then. It is usually the part, its wiring or a connector with poor contact.
| Code | P2407 |
|---|---|
| System | Engine and transmission |
| Group | P24xx, EGR, EVAP and particulate filter |
| Type | Generic: it means the same on every make |
How to read and clear P2407 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P2407 with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P2403 The signal of the fuel vapour leak detection pump has a broken or disconnected
- P2404 The signal of the fuel vapour leak detection pump gives readings outside the
- P2405 The signal of the fuel vapour leak detection pump gives a lower signal than
- P2406 The signal of the fuel vapour leak detection pump gives a higher signal than
- P2408 The fuel cap warning sensor or switch circuit has a fault
- P2409 The fuel cap warning sensor or switch works outside its range or abnormally
- P240A The heater control of the fuel vapour leak detection pump has a broken or
- P240B The heater control of the fuel vapour leak detection pump gives a lower signal
- P2400 EVAP leak detection pump control circuit open or faulty
- P2413 Exhaust gas recirculation (EGR) system performance
- P2414 O2 sensor exhaust sample error (bank 1, sensor 1)
- P2425 EGR cooler valve control circuit open or faulty
What does code P2407 mean?
The signal of the fuel vapour leak detection pump fails now and then. It is usually the part, its wiring or a connector with poor contact.
How do you clear P2407?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P2407 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
