P2AF7: The starter motor relay D control has a broken or disconnected wire
The starter motor relay D control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
| Code | P2AF7 |
|---|---|
| System | Engine and transmission |
| Group | P2Axx, Engine and emissions |
| Type | Generic: it means the same on every make |
How to read and clear P2AF7 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P2AF7 with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P2AF3 The starter motor relay C control gives a lower signal than normal
- P2AF4 The starter motor relay C control gives a higher signal than normal
- P2AF5 The starter motor relay C has got stuck
- P2AF6 The starter motor relay C has got stuck
- P2AF8 The starter motor relay D control gives a lower signal than normal
- P2AF9 The starter motor relay D control gives a higher signal than normal
- P2AFA The starter motor relay D has got stuck
- P2AFB The starter motor relay D has got stuck
- P2A00 O2 sensor circuit range/performance (bank 1, sensor 1)
What does code P2AF7 mean?
The starter motor relay D control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
How do you clear P2AF7?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P2AF7 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
