P081E: Gearbox clutch B slips excessively
Gearbox clutch B slips excessively.
| Code | P081E |
|---|---|
| System | Engine and transmission |
| Group | P08xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P081E with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P081E with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P081A The starter disable circuit signal is too low
- P081B The starter disable circuit signal is too high
- P081C The parking input has an electrical fault
- P081D The neutral input has an electrical fault
- P0820 The gear lever X Y position sensor has an electrical fault
- P0821 The gear lever X position has an electrical fault
- P0822 The gear lever Y position has an electrical fault
- P0823 The gear lever X position fails now and then
- P0841 Transmission fluid pressure sensor/switch A: circuit range or performance
- P0842 Transmission fluid pressure sensor/switch A: circuit low
- P0843 Transmission fluid pressure sensor/switch A: circuit high
- P0868 Transmission fluid pressure low
What does code P081E mean?
Gearbox clutch B slips excessively.
How do you clear P081E?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P081E comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
