P279A: The transfer case is not getting the correct ratio in high range
The transfer case is not getting the correct ratio in high range. It is usually the transfer case oil level, its shift motor or internal wear.
| Code | P279A |
|---|---|
| System | Engine and transmission |
| Group | P27xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P279A with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P279A with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P2796 The gearbox oil auxiliary pump control has a broken or disconnected wire
- P2797 The auxiliary gearbox oil pump gives readings outside the normal range
- P2798 The gearbox oil auxiliary pump control gives a lower signal than normal
- P2799 The gearbox oil auxiliary pump control gives a higher signal than normal
- P279B The transfer case is not getting the correct ratio in low range
- P279C The transfer case is not getting the correct ratio in neutral
- P279D The four-wheel drive range signal has an electrical fault
- P279E The four-wheel drive range signal gives readings outside the normal range
What does code P279A mean?
The transfer case is not getting the correct ratio in high range. It is usually the transfer case oil level, its shift motor or internal wear.
How do you clear P279A?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P279A comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
