P278E: The gearbox kickdown switch circuit fails intermittently or gives erratic
The gearbox kickdown switch circuit fails intermittently or gives erratic signals.
| Code | P278E |
|---|---|
| System | Engine and transmission |
| Group | P27xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P278E with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P278E with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P2789 The adaptive clutch A learning in the limit is not working properly
- P278B The gearbox kickdown switch circuit works outside the expected range
- P278C The gearbox kickdown switch circuit signal is too low
- P278D The gearbox kickdown switch circuit signal is too high
- P278F The adaptive clutch B learning in the limit is not working properly
- P2790 The gate selection direction has an electrical fault
- P2791 The gate selection direction gives a lower signal than normal
- P2792 The gate selection direction gives a higher signal than normal
What does code P278E mean?
The gearbox kickdown switch circuit fails intermittently or gives erratic signals.
How do you clear P278E?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P278E comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
