P2761: The torque converter clutch pressure control solenoid control has a broken or
The torque converter clutch pressure control solenoid control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
| Code | P2761 |
|---|---|
| System | Engine and transmission |
| Group | P27xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P2761 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P2761 with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P275D The gearbox D oil temperature sensor gives a higher signal than normal
- P275E The gearbox D oil temperature sensor fails now and then
- P275F The gearbox oil has reached too high a temperature
- P2760 The torque converter clutch pressure control solenoid control fails now and then
- P2762 The torque converter clutch pressure control solenoid control gives readings
- P2763 The torque converter clutch pressure control solenoid control gives a higher
- P2764 The torque converter clutch pressure control solenoid control gives a lower
- P2765 The circuit of speed sensor B for the gearbox input shaft or turbine has a fault
What does code P2761 mean?
The torque converter clutch pressure control solenoid control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
How do you clear P2761?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P2761 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
