P2010: The intake manifold flap control solenoid circuit voltage is too high
The intake manifold flap control solenoid circuit voltage is too high. The solenoid, connector and wiring need checking.
| Code | P2010 |
|---|---|
| System | Engine and transmission |
| Group | P20xx, Emissions: catalysts and AdBlue |
| Type | Generic: it means the same on every make |
How to read and clear P2010 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P2010 with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P200C The diesel particulate filter (bank 1) is getting too hot
- P200D The diesel particulate filter (bank 2) is getting too hot
- P200E The catalytic converter system (bank 2) is getting too hot
- P200F The catalytic converter system (bank 2) is getting too hot
- P2011 The intake manifold air control actuator circuit on bank 2 is open
- P2012 The circuit signal for the intake manifold air control actuator on bank 2 is
- P2013 The circuit signal for the intake manifold air control actuator on bank 2 is
- P2014 There is a fault in the position sensor or switch circuit for the intake air
- P2002 Diesel particulate filter efficiency below threshold (bank 1)
- P2003 Diesel particulate filter efficiency below threshold (bank 2)
- P2004 Intake manifold runner control stuck open (bank 1)
- P2005 Intake manifold runner control stuck open (bank 2)
What does code P2010 mean?
The intake manifold flap control solenoid circuit voltage is too high. The solenoid, connector and wiring need checking.
How do you clear P2010?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P2010 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
