P05FE: The active grille air shutter C has got stuck
The active grille air shutter C has got stuck. It is usually dirt, wear or the motor that moves it.
| Code | P05FE |
|---|---|
| System | Engine and transmission |
| Group | P05xx, Speed, idle and auxiliary inputs |
| Type | Generic: it means the same on every make |
How to read and clear P05FE with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P05FE with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P05FA The Stop Start status line gives a lower signal than normal
- P05FB The Stop Start status line gives a higher signal than normal
- P05FC The cold start fuel pressure (bank 2) gives readings outside the normal range
- P05FD The turbocharger boost control A temperature is above normal
- P05FF The brake pressure sensor brake pedal position sensor gives readings that do
- P0500 Vehicle speed sensor malfunction
- P0501 Vehicle speed sensor range/performance
- P0502 Vehicle speed sensor circuit low input
- P0503 Vehicle speed sensor intermittent, erratic or high
What does code P05FE mean?
The active grille air shutter C has got stuck. It is usually dirt, wear or the motor that moves it.
How do you clear P05FE?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P05FE comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
