C05C4: The brake pressure sensor F needs calibrating
The brake pressure sensor F needs calibrating. It is solved at the workshop with a diagnostic tool.
| Code | C05C4 |
|---|---|
| System | Chassis |
| Group | C05xx, Chassis |
| Type | Generic: it means the same on every make |
How to read and clear C05C4 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see C05C4 with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- C05C0 The brake pedal position sensor A needs its learning procedure
- C05C1 The brake pedal position sensor B needs its learning procedure
- C05C2 The brake booster motor A is getting too hot
- C05C3 The brake booster motor A power supply has an electrical fault
- C05C5 The brake pressure sensor F gives readings outside the normal range
- C05C6 The brake pressure sensor F gives a lower signal than normal
- C05C7 The brake pressure sensor F gives a higher signal than normal
- C05C8 The brake pressure sensor F has a broken or disconnected wire
What does code C05C4 mean?
The brake pressure sensor F needs calibrating. It is solved at the workshop with a diagnostic tool.
How do you clear C05C4?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, C05C4 comes back.
