P2783: The torque converter temperature is above normal
The torque converter temperature is above normal. It may be the part itself, its connector or the wiring.
| Code | P2783 |
|---|---|
| System | Engine and transmission |
| Group | P27xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P2783 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P2783 with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P2779 The gear reduction switch gives readings outside the normal range
- P2780 The gear reduction switch gives a lower signal than normal
- P2781 The gear reduction switch gives a higher signal than normal
- P2782 The gear reduction switch fails now and then
- P2784 The A and B speed signals from the gearbox input shaft or turbine do not agree
- P2785 The clutch actuator temperature is above normal
- P2786 The gear shift actuator temperature is above normal
- P2787 The clutch temperature is above normal
What does code P2783 mean?
The torque converter temperature is above normal. It may be the part itself, its connector or the wiring.
How do you clear P2783?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P2783 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
