P0902: The clutch actuator gives a lower signal than normal
The clutch actuator gives a lower signal than normal. It is usually the part, its wiring or a connector with poor contact.
| Code | P0902 |
|---|---|
| System | Engine and transmission |
| Group | P09xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P0902 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P0902 with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P0900 The clutch actuator circuit has a broken or disconnected wire
- P0901 The clutch actuator gives readings outside the normal range
- P0903 The clutch actuator gives a higher signal than normal
- P0904 The gate selection position has an electrical fault
- P0905 The gate selection position gives readings outside the normal range
- P0906 The gate selection position gives a lower signal than normal
What does code P0902 mean?
The clutch actuator gives a lower signal than normal. It is usually the part, its wiring or a connector with poor contact.
How do you clear P0902?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P0902 comes back.
