P077F: The gear ratio for reverse gear 2 is incorrect
The gear ratio for reverse gear 2 is incorrect.
| Code | P077F |
|---|---|
| System | Engine and transmission |
| Group | P07xx, Transmission |
| Type | Generic: it means the same on every make |
How to read and clear P077F with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P077F with its description and whether it’s confirmed, pending or permanent.
This code is usually stored by the gearbox control unit. If the car reports it over standard OBD, you read it for nothing with FREE; to read it straight from the gearbox control unit, with its description and clearing, you need PRO.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P077B The output speed sensor circuit direction is not working properly
- P077C The gearbox output speed sensor circuit signal is low
- P077D The gearbox output speed sensor circuit signal is too high
- P077E The gearbox oil temperature sensors give readings that do not agree
- P0780 Automatic gearbox shift malfunction
- P0781 Automatic gearbox 1-2 shift malfunction
- P0782 Automatic gearbox 2-3 shift malfunction
- P0783 Automatic gearbox 3-4 shift malfunction
- P0700 Transmission control system: fault detected
- P0701 Transmission control system: range/performance
- P0702 Transmission control system: electrical fault
- P0703 Torque converter/brake switch B: circuit fault
What does code P077F mean?
The gear ratio for reverse gear 2 is incorrect.
How do you clear P077F?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P077F comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
