P00C8: The fuel pressure regulator A solenoid power supply voltage control has a
The fuel pressure regulator A solenoid power supply voltage control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
| Code | P00C8 |
|---|---|
| System | Engine and transmission |
| Group | P00xx, Air, fuel and emissions |
| Type | Generic: it means the same on every make |
How to read and clear P00C8 with Final OBD
Plug an OBD2 scanner in under the steering wheel, switch the ignition on and open Final OBD. Under Faults you’ll see P00C8 with its description and whether it’s confirmed, pending or permanent.
If the engine stores it over standard OBD, with FREE you read this code with its explanation for nothing and clear it. With PRO you also read the faults of every control unit and clear them in all of them.
Clearing the code only turns the light off: if the cause is still there, it comes back. Clear it once it’s fixed, and not right before an inspection. It’s all in how to read and clear fault codes and in inspections and OBD.
Similar codes
- P00C4 Bypass valve B of the turbocharger or supercharger has a mechanical fault
- P00C5 The turbocharger B turbine is turning faster than it should
- P00C6 Fuel rail pressure is too low while cranking the engine
- P00C7 The multiple intake air pressure measurement system sensor (bank 1) gives
- P00C9 The fuel pressure regulator A solenoid power supply voltage control gives a
- P00CA The fuel pressure regulator A solenoid power supply voltage control gives a
- P00CB The fuel volume regulator solenoid power supply voltage control has a broken or
- P00CC The fuel volume regulator solenoid power supply voltage control gives a lower
- P0010 Camshaft A actuator control: open circuit (bank 1)
- P0011 Camshaft A timing over-advanced (bank 1)
- P0012 Camshaft A timing over-retarded (bank 1)
- P0013 Camshaft B actuator control: open circuit (bank 1)
What does code P00C8 mean?
The fuel pressure regulator A solenoid power supply voltage control has a broken or disconnected wire. It is usually a broken wire, a loose connector or the part itself.
How do you clear P00C8?
With an OBD2 scanner and an app like Final OBD, which clears it for free if it’s stored by the engine control unit. But clearing it only turns the light off: if the cause isn’t fixed, P00C8 comes back.
Read it on your car
Final OBD reads and clears engine faults through standard OBD for free, each one explained in plain English. With PRO it also reads the faults of every control unit, each make’s own codes included, and clears them in all of them.
